I understand the intent, but feel that there are so many other loopholes that put much worse weapons on the street than a printer. Besides, my prints can barely sustain normal use, much less a bullet being fired from them. I would think that this is more of a risk to the person holding the gun than who it’s pointing at.

  • Wogi@lemmy.world
    link
    fedilink
    English
    arrow-up
    20
    ·
    1 year ago

    It’s all CNC. All the way down. Always was.

    Seriously, 3d printers are just CNC machines, they use the same code the mill I use that was built in 1989 uses.

    • ezures
      link
      fedilink
      English
      arrow-up
      5
      ·
      1 year ago

      Yes, they added some new g codes for the extruder bit (even that is just used as an axis), but otherwise you could hand code a 3d print. Probably not a good idea, but could be done. CNC is cool