I am somewhat new to 3d printing and i am playing around with different filaments and print plates on my cheap ender3 v3 se.

Right now I am observing a weird adhesion-issue i have not seen before: The copper-silk filament has trouble sticking to the printplate, but only in some places of the plate.

My guess it’s either some dirt/oil on the printplate. Or maybe the silk-pla has bad adhesion.

What do you think?

This printplate is this (but glued over the original printplate): https://www.amazon.de/dp/B0CL5FYHBR

The filament is this: https://www.amazon.de/dp/B09CPBRQXS

some clarification for the video: all corners of the first layer should have been rectangular. Instead some corner lost adhesion and become roundish. Here is the view from the slicer: https://imgur.com/rwA0fQW

  • killeronthecorner@lemmy.world
    link
    fedilink
    English
    arrow-up
    7
    arrow-down
    2
    ·
    edit-2
    9 months ago
    1. Try increasing hotend temp for first few layers and hotbed temp throughout
    2. Try moving z closer for first layer
    3. Repeat both of above in small increments

    FWIW, those PEI sheets usually need higher bed temp than the regular sheets

    • bort@feddit.deOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      9 months ago

      Try increasing hotend temp for first few layers and hotbed temp throughout

      the default from the printer was 60C. I had some better results with 70C. But the issue still happend with more delicate prints.

      those PEI sheets usually need higher bed temp than the regular sheets

      thanks. I didn’t know that. What magnitude are we talking here (like: 10K more for PEI-sheets? or more like 1K?)

      Try moving z closer for first layer

      I think this may be the solution. How much should I change the z-offset? (the print in the video has 0.2mm layer height. And the worst-adhession issues happened with 0.1mm)

      • Tolookah@discuss.tchncs.de
        link
        fedilink
        English
        arrow-up
        5
        ·
        9 months ago

        K Kelvin, not K thousands of degrees… It’s too early to think.

        You may also have a bed flatness problem, if it’s not a dirty plate.