The difference with wireless listening vs. charging is that the former doesn’t need close to 2x the power of the cable-bound method and doesn’t destroy the phone’s battery in the process, unlike the latter
Wireless listening absolutely needs more than 2x the power of wired listening. It also needs charging an entire other device. You’re right that it doesn’t affect the phone battery, though I don’t think wireless charging “destroys” it.
It warms it up, and you’re not going to get the absolute maximum battery life out of it if you’re wireless, but the impact usually isn’t that big, unless you’re really cooking it. Using the standard fast charger that comes with your phone is probably going to put about as much, if not more wear than a. 10W wireless charger.
You’re not meant to wirelessly charge it by sticking it in the microwave.
Wireless listening absolutely needs more than 2x the power of wired listening. It also needs charging an entire other device
It might be more than that. A wired headset is incredibly simple, unless you’re running a ridiculous amplifier through it. It’s just two speakers, maybe a microphone and button if it’s a mobile headset.
By comparison, wireless listening would usually need the audio encoder/decoder chips, the Bluetooth receiver/transmitter, the processors for the pairing/controls/noise cancellation, and the speakers on top of that. That’s not a small amount of componentry.
I’ve tried using wireless charging in a friend’s car on my iPhone SE a few weeks back.
Result: notification that charging had (!) to be stopped at around 50% due to overheating and was poised to continue once the iPhone had cooled down sufficiently. It never continued as that was all I needed to know about the current state of wireless charging with light usage on the side.
Good point on the wireless listening and ear pieces needing a battery as well, though. I guess with those it comes down to convenience for most buyers.
Some people will always want wires to transfer data,
But that group of people is growing smaller and smaller with each year. I haven’t used a phone cable to transfer files once in the last 8 years. Phones just sync to cloud.
Same. I think the last time I used a cable to transfer data onto my phone was iTunes syncing my iPhone 5s music. Once I moved to Spotify I never needed to sync again.
It’s not the use case of everyone, but I’d bet the majority of iPhone users haven’t used a data transfer in years
I suspect cables are used more on Android because its filesystem is open so you can basically use an Android as a flash drive, which is very convenient at times.
Also since Androids in general have a way faster wired connection, it’s more likely to be used for that.
Unlike iOS, Android also doesn’t have a way to easily transfer files over WiFi by default.
Whereas if you’re embedded in the Apple ecosystem, you can airdrop something from your iPhone to your Mac straight out of the box (after getting set up).
You can install the share app on Windows for the same experience.
I only use it for small files or photos. I use a cable for bigger files like movies or whatever, since it’s much faster.
Using a cable with Android is also very easy since you don’t need any apps or anything. You just have to click a notification and set the USB mode to “file transfer” from “charge only”, after that it just works on pretty much every device. Fast USB ports are also useful because you can connect accessories to your phone like gigabit ethernet, and especially flash drives.
I suspect iPhone users very rarely if ever, transfer big files since the iOS file system is so locked down. The only big thing I can imagine that they would need to transfer is filmed 4k video.
I don’t think they intended to imply that faster USB support _isn’t needed _, but rather they are making a mockery of how absolutely absurd this reality is.
And if USB SS+ (aka USB 3.1 gen 2 aka USB 3.2 gen 2×1) with 10 Gb/s is not enough for you, the newest iteration of the USB standard USB 4.0 version 2.0 has USB4 gen 4 at 80 Gb/s
Edit: for reference: Wi-Fi 4 supports up to 600 Mb/s or .6 Gb/s, while Wi-Fi 7 supports up to 46.12 Gb/s
It would actually be a lot safer if the charging port was only able to supply power. People plug their shit into random cables all the time and it’s been a vector for compromise.
That’s a good point though the port is also needed to pair an iPhone or iPad to a Mac/PC (the famous ‘Trust This Device’ screen can only be triggered if a device tries to access the phones data via USB) which is required to do any backups / music or picture syncs in the first place. ,nd it’s also necessary if youre a developer as - even at USB2.0 speeds that people complain about here - it is still faster to test and debug applications than via wireless.
TFW a wifi transfer literally loads files from your phone faster than a fucking cable.
That’s the point. Expect the iPhone 17 to be portless to the consumer.
There has to be a USB-C. Some people will always want wires to transfer data, even if it’s through their “wireless charger”, which is proprietary.
And some people will always want a headphone jack… oh wait…
The difference with wireless listening vs. charging is that the former doesn’t need close to 2x the power of the cable-bound method and doesn’t destroy the phone’s battery in the process, unlike the latter
Wireless listening absolutely needs more than 2x the power of wired listening. It also needs charging an entire other device. You’re right that it doesn’t affect the phone battery, though I don’t think wireless charging “destroys” it.
It warms it up, and you’re not going to get the absolute maximum battery life out of it if you’re wireless, but the impact usually isn’t that big, unless you’re really cooking it. Using the standard fast charger that comes with your phone is probably going to put about as much, if not more wear than a. 10W wireless charger.
You’re not meant to wirelessly charge it by sticking it in the microwave.
It might be more than that. A wired headset is incredibly simple, unless you’re running a ridiculous amplifier through it. It’s just two speakers, maybe a microphone and button if it’s a mobile headset.
By comparison, wireless listening would usually need the audio encoder/decoder chips, the Bluetooth receiver/transmitter, the processors for the pairing/controls/noise cancellation, and the speakers on top of that. That’s not a small amount of componentry.
I’ve tried using wireless charging in a friend’s car on my iPhone SE a few weeks back.
Result: notification that charging had (!) to be stopped at around 50% due to overheating and was poised to continue once the iPhone had cooled down sufficiently. It never continued as that was all I needed to know about the current state of wireless charging with light usage on the side.
Good point on the wireless listening and ear pieces needing a battery as well, though. I guess with those it comes down to convenience for most buyers.
But that group of people is growing smaller and smaller with each year. I haven’t used a phone cable to transfer files once in the last 8 years. Phones just sync to cloud.
Same. I think the last time I used a cable to transfer data onto my phone was iTunes syncing my iPhone 5s music. Once I moved to Spotify I never needed to sync again.
It’s not the use case of everyone, but I’d bet the majority of iPhone users haven’t used a data transfer in years
I suspect cables are used more on Android because its filesystem is open so you can basically use an Android as a flash drive, which is very convenient at times.
Also since Androids in general have a way faster wired connection, it’s more likely to be used for that.
Unlike iOS, Android also doesn’t have a way to easily transfer files over WiFi by default.
Whereas if you’re embedded in the Apple ecosystem, you can airdrop something from your iPhone to your Mac straight out of the box (after getting set up).
You can install the share app on Windows for the same experience.
I only use it for small files or photos. I use a cable for bigger files like movies or whatever, since it’s much faster.
Using a cable with Android is also very easy since you don’t need any apps or anything. You just have to click a notification and set the USB mode to “file transfer” from “charge only”, after that it just works on pretty much every device. Fast USB ports are also useful because you can connect accessories to your phone like gigabit ethernet, and especially flash drives.
I suspect iPhone users very rarely if ever, transfer big files since the iOS file system is so locked down. The only big thing I can imagine that they would need to transfer is filmed 4k video.
Yeah same, if I need a transfer I use gdrive
I don’t, for privacy reasons. I use either cable or drop.lol
Consumer demands appear to just kinda bounce off of Apple, it’s remarkable really.
USB 3.0 is way faster than WiFi and some phones even gave 3.1
… iPhone has USB 2.0
Yes, I know that,
The comment above implied that faster USB support isn’t needed because WiFi is faster anyways (obviously wrong).
I don’t think they intended to imply that faster USB support _isn’t needed _, but rather they are making a mockery of how absolutely absurd this reality is.
That is possible.
And if USB SS+ (aka USB 3.1 gen 2 aka USB 3.2 gen 2×1) with 10 Gb/s is not enough for you, the newest iteration of the USB standard USB 4.0 version 2.0 has USB4 gen 4 at 80 Gb/s
Edit: for reference: Wi-Fi 4 supports up to 600 Mb/s or .6 Gb/s, while Wi-Fi 7 supports up to 46.12 Gb/s
That’s his point.
I dont know anyone who transfers anything besides power to the iphone via cable. What are you guys doing? Syncing it with itunes?
Apple car play would be a bitch if I don’t have a port since it doesn’t have wireless carplay. And my car is a 2023
Well if you don’t want to subscribe to iCloud, how can you do it except with iTunes?
To be honest I’d really want to be able to create an image of my iPhone and back it up on my kdrive (a cloud storage service).
This was my thought exactly. I would sooner transfer over Wi-Fi than cable. This is a charging port to me.
It would actually be a lot safer if the charging port was only able to supply power. People plug their shit into random cables all the time and it’s been a vector for compromise.
That’s a good point though the port is also needed to pair an iPhone or iPad to a Mac/PC (the famous ‘Trust This Device’ screen can only be triggered if a device tries to access the phones data via USB) which is required to do any backups / music or picture syncs in the first place. ,nd it’s also necessary if youre a developer as - even at USB2.0 speeds that people complain about here - it is still faster to test and debug applications than via wireless.