This is an automated archive.

The original was posted on /r/sffpc by /u/FUNTOWNE on 2023-09-05 14:44:44+00:00.

Hi Everyone -

I am using a DAN A4 SFX with an undervolted Inno 3D 4070 Ti. It is snug, but it works great!

Could anyone confirm if the little motherboard standoffs that move the PCIe slot away from the center spine of the case are recommended? I see users with the 30x0 series doing this for the rear intake fan to get a bit more room, but it doesn’t seem to be “needed” for the Inno 3D card. Instructions for the 3080 FE for reference to what I did for my 4070 Ti:

Doing this little mod pushes the fans of the 4070 Ti very close to, but not touching, the case panel. I am not sure if this is helping force more cooler air in, or is restricting airflow a bit. Any thoughts from the community?

Thanks!